Declining A Call; Selecting The Limit Sets; Figure 218 Measure Mode - Voip Incoming Call - JDS Uniphase DSAM-3500 User Manual

21128026 R001 DSAM Help User Guide.book Page 241 Thursday, February 5, 2009 2:02 PM

Declining a Call

Selecting the
Limit Sets
DSAM Help User Guide
Figure 218 Measure Mode – VoIP Incoming Call
To accept a call
1 Press the Accept softkey.
To decline a call
1 Press the Ignore softkey. ("Incoming call... " continues to display
until the other party hangs up.)
NOTE
After you press the Accept or Ignore softkey, the original softkeys
reappear.
To select the limits sets
1 Using the arrow keys, select a set of measurement limits – Tap,
Ground Block, TV, Cable Modem, Proof, or custom limits 1-
3.
OR
2 To access the Limit Sets screen, select Edit.
This allows you to edit limit set parameters to meet your needs.
3 Using the arrow keys, select a menu option.
4 Press ENTER.
Rev. 001
Chapter 9 Measure Mode – Service Tab
VoIP
241