Fig. 84: Setting the thrust movement of the feed dog (2)
(2) - Stitch adjustment linkage
(3) - Gage (gage 8,
2. Loosen the screws of the pusher eccentric (5).
3. Lock the machine in place at position B ( p. 16).
4. Insert the gage (3) into the slot (4).
5. Turn the pusher eccentric (5) such that the edges of the gage (3) rest
6. Tighten the screws of the pusher eccentric (5).
7. Check if the lower shaft has axial play.
84
②
p. 14)
on the stitch adjustment linkage (2).
(4) - Slot
(5) - Pusher eccentric
Service Instructions 195 - 00.0 - 12/2017
Feed dog
⑤
④
③