Table of Contents
Advertisement
Edge cutter
Fig. 113: Setting the height and lateral position of the top blade (2)
(4) - Screw
(5) - Screw
To set the height and lateral position of the top blade:
1. Switch on the edge cutter.
2. Turn the handwheel until the top blade (1) is at the bottom dead center.
3. Loosen the screw (4).
4. Loosen the screw (5).
5. Adjust the top blade (1) such that the front tip (3) reaches the cutting
6. Tighten the screw (4).
7. Tighten the screw (5).
8. Turn the handwheel until the top blade is at the top dead center.
9. Loosen the screw (6).
10. Align the point of the blade with the counter blade.
11. Tighten the screw (6).
12. Carry out a cutting test.
13. Adjust the settings again if necessary.
Service Instructions 195 - 00.0 - 12/2017
④
⑤
edge of the bottom blade.
⑥
(6) - Screw
111
Advertisement
Table of Contents
