Table of Contents
Advertisement
Maintenance
Fig. 125: Lubricating the hook (3)
(3) - Dipstick
(4) - Minimum level marking
6. Check if the oil level is between the minimum level marking (4) and the
7. Tighten the screw plug (1) if the oil level is sufficient.
8. Top off the oil if the oil level is low.
Topping off the oil
To top off the oil in the hook drive housing:
1. Open the right hook cover ( p. 30).
2. Loosen the screw plug (1) on the filler opening.
Important
Only top off the oil a little at a time. When finished, check the oil level.
If necessary, repeat these 2 steps several times until the oil level is just
below the maximum level marking (5) of the dipstick (3).
There must not be too much oil in the hook drive housing.
3. Carefully refill oil through the filler opening no higher than the maximum
4. Check the oil level again.
5. If necessary, repeat step 2 and 3 until the oil level is just below the
6. Tighten the screw plug (1).
Service Instructions 195 - 00.0 - 12/2017
④
maximum level marking (5).
level marking (5) of the dipstick (3).
maximum level marking (5) of the dipstick (3).
③
⑤
(5) - Maximum level marking
129
Advertisement
Table of Contents
