Table of Contents
Advertisement
Setting the adjusting disk relative to the arm shaft crank
2. To allow for the cylinder (11) to be moved, loosen the locking
3. To gain access to the screw in the belt pulley, move the cylinder (11)
Fig. 28: Setting the adjusting disk relative to the arm shaft crank (4)
(11) - Cylinder
(12) - Threaded pin
4. Turn the handwheel until the threaded pin (12) in the toothed belt (13)
5. If necessary, move the toothed belt (14) slightly to the left to gain access
6. Loosen the threaded pin (12).
Service Instructions 195 - 00.0 - 12/2017
washer (10) using a screwdriver.
to the side by a few millimeters (the figure below shows the machine
from the rear).
⑫
⑬
can be accessed from the top.
to the threaded pin (12).
(13) - Toothed belt wheel
(14) - Toothed belt
⑭
⑪
37
Advertisement
Table of Contents
