Table of Contents
Advertisement
Fig. 29: Setting the adjusting disk relative to the arm shaft crank (5)
(2) - Locking peg (locking peg 3
(15) - Locking opening
7. Turn the handwheel (16) to position A (3).
8. Use the locking opening (15) to insert a 2nd locking peg (2) and lock
9. If the machine cannot be locked in place at position A (3), slightly adjust
10. Tighten the threaded pin (12).
11. If necessary, slide the toothed belt (14) slightly back to the right.
12. Slide the cylinder (11) all the way back to the right.
13. Secure the cylinder (11) with the locking washer (10).
14. To remove the lock, pull out both locking pegs (2) ( p. 16).
38
Setting the adjusting disk relative to the arm shaft crank
⑮
②
the machine in place at position A (3) of the adjusting disk (6).
the position of the toothed belt wheel (13).
The toothed belt (14) must be positioned completely on top of the
toothed belt wheel (13).
p. 14)
(16) - Handwheel
Service Instructions 195 - 00.0 - 12/2017
⑯
Advertisement
Table of Contents
