Table of Contents
Advertisement
Setting the thread cutter
The thread advancing houses a flight of 5 steps. Depending on how far the
stop is placed inside the thread advancing device, the nose will hit one of
these steps when the device is extending.
Proper setting
No more needle and hook thread than is required should be advanced as
this determines the length of the thread end remaining at the seam
beginning.
To set the thread advancing device for needle and hook thread:
1. Adjust the stop (2) on the thread advancing device (1):
The thread advancing device (1) extends less far.
The thread advancing device (1) extends further.
Service Instructions 195 - 00.0 - 12/2017
• Advance less thread: The stop (2) may protrude further into the
thread advancing device (1).
• Advance more thread: The stop (2) may protrude less far into the
thread advancing device (1).
105
Advertisement
Table of Contents
