Table of Contents
Advertisement
Setting the thread cutter
2. Tighten the thread cutter on top of the gage (9).
3. Tighten the counter blade (8) so that the notch (1) is level with the
The thread clamping plate (6) should keep the cut end of the hook
Disturbance
If set too tight, the thread clamping plate (6) may cause ruffing at the seam
beginning.
4. Carefully align the support plate (4) to ensure that the movable
5. Perform a cutting test with the desired thread.
6. If the cut made is not clean, check if the movable blade (5) is sharp.
7. Replace the movable blade (5) if necessary ( p. 102).
8. If necessary, set the movable blade (5) to its cutting position by carefully
9. Unscrew the thread cutter from the gage (9).
10. Assemble the thread cutter back into the machine.
Service Instructions 195 - 00.0 - 12/2017
edge (3) of the mounting plate (2).
To do so, insert a screwdriver into the 2nd notch and move the
counter blade (8).
thread slightly clamped to ensure the proper beginning of the next
seam.
blade (5) is not pushed aside by the counter blade (8) when cutting
thick threads.
aligning the intermediate plate (7) until the cut is made reliably.
99
Advertisement
Table of Contents
