Dürkopp Adler 195 Service Instructions Manual page 142

Error code
1004
1005
1006
1007
1008
1010
1011
1012
1052
1053
1054
1055
1203
140
Type Possible cause
Error
Sewing motor error:
Incorrect sewing motor
direction of rotation
Error Motor blocked
Error Maximum speed
exceeded
Error Error in the reference run • Replace encoder
Error Encoder error
Error External synchronizer
plug (Sub-D, 9-pin) not
connected
Error Encoder Z pulse missing • Switch off the control.
Error Synchronizer fault
Error Sewing motor
overcurrent, internal
current increase >25 A
Error Sewing motor
overvoltage
Error Internal short circuit
Error Sewing motor overload
Information Position not reached
(during thread cutting,
reversal, etc.)
Troubleshooting
Remedial action
• Replace encoder
• Check plug assignment and
change, if necessary
• Check wiring in machine
distributor and change it, if
necessary
• Test motor phases and check
for correct value
• Eliminate stiff movement in the
sewing machine
• Replace encoder
• Replace the motor
• Replace encoder
• Perform reset
• Check machine class (t 51 04)
• Eliminate stiff movement in the
sewing machine
• Replace encoder
• Connect cable of external
synchronizer to control, use
correct connection (Sync)
• Only required for machines with
transmission!
Turn handwheel and switch on
the control again
• If error is not corrected, check
encoder
• Replace the synchronizer
• Check selection of class
• Replace control
• Replace sewing motor
• Replace encoder
• Check selection of class
• Replace control
• Replace control
• Eliminate stiff movement in
the sewing machine
• Replace encoder
• Replace sewing motor
• Check and, if necessary,
change controller settings.
Mechanical changes to the
machine. (e. g. thread cutting
setting, belt tension, etc.)
• Check position (thread lever at
top dead center)
Service Instructions 195 - 00.0 - 12/2017