Edge cutter
Fig. 111: Setting the cutter bar standstill during shut-off
(1) - Pull rod
(2) - Screw
To set the cutter bar standstill during shut-off:
1. Loosen the screw (2) on the clamping piece (3).
2. Turn the pull rod (1) such that the cutter bar makes only the slightest
3. Re-tighten the screw (2).
Service Instructions 195 - 00.0 - 12/2017
①
movement when the handwheel is turned.
②
(3) - Clamping piece
③
109