Fujitsu Arrows NX F-01J Instruction Manual page 92

4
Hold mark over a card reader
Mark
✔INFORMATION
･
When reading/writing data, you need not activate Osaifu-
Keitai application.
･
Powering on the terminal is not necessary, but if the terminal
remains powered off for a long time or battery is low, the
function may not be available.
･
According to the installed Osaifu-Keitai application or its
setting status, during screen lock or when the screen is off,
the service may not be available by holding the terminal over
the IC card reader.
･
For non-subscriber to sp-mode, a part of Osaifu-Keitai service
may not be available.
IC card reader
◆ Using "かざしてリンク対応サービス
(Kazashite-Link compatible service)"
1
From the Home screen,
tools]→[NFC/Osaifu-Keitai Settings]
･
When the password setting screen for NFC/Osaifu-
Keitai lock appears, follow the on-screen instructions to
set password.
･
If [Lock NFC/Osaifu-Keitai] is marked, unmark the
checkbox.
2
Mark [Reader/Writer, P2P]
3
Hold mark over a device equipped an NFC
module, a smart poster, etc.
･
In addition, you can exchange information between
terminals using Android Beam.→P163
❖
NFC/Osaifu-Keitai Settings
Select NFC Type you use.
1
From the Home screen,
tools]→[NFC/Osaifu-Keitai Settings]
2
[NFC Type setting]→[FeliCa / Type A / Type B
(Default value) / [FeliCa / Type A] / [FeliCa /
Type B]
90
→[Settings]→[Useful
→[Settings]→[Useful
Applications