Fujitsu Arrows NX F-01J Instruction Manual page 19

・
Do not place the terminal near an air-conditioner outlet.
- The rapid change in temperature may cause condensation,
causing internal corrosion and malfunction.
・
Do not apply excessive force to the terminal.
- Putting the terminal into a tightly packed bag or sitting on
the terminal in your pocket might damage the display or
internal circuit board resulting in a malfunction. Also,
keeping an external device connected to the external
connection terminal might damage the connector
resulting in a malfunction.
・
Do not rub or scrape the display with a metal piece etc.
- May scratch the display, causing malfunction or damage.
・
Use the optional products specified by NTT DOCOMO for
your terminal.
- If you use optional products other than specified, it may
cause malfunction or damage.
・
Read the instruction manuals supplied with individual
optional devices.
・
Do not drop the terminal or subject it to shocks.
- May cause malfunction or damage.
◆ The terminal
・
Do not press the surface of the touch panel strongly or
operate it with sharp objects such as a nail, a ballpoint pen
and a pin.
- It may damage the touch panel.
・
Avoid extreme temperature.
- Use the terminal where the temperature ranges between 5
and 40℃ (limited to the temporary use in a bathroom etc.
when temperature is above 36℃) and humidity ranges
between 45 and 85%.
・
The terminal may affect land-line phones, TVs or radios in
use nearby, so use it as far as possible from these
appliances.
・
Be sure to back up the data you saved in the terminal on a
microSD card, PC or cloud service, or keep a separate note.
- If the data is deleted, DOCOMO assumes no responsibility
for the loss of any data.
・
Do not plug external devices into the external connection
jack at a slant, or do not pull it forcibly while it is plugged.
- May cause malfunction or damage.
・
It is normal for the terminal to become warm during use or
charging. Continue to use it.
・
Do not leave the terminal with the camera in areas under
strong direct sunlight.
- May cause discoloring or burn-in of elements.
・
Use the terminal with the slot cap closed.
- Not doing so may cause malfunction due to entering
foreign objects such as liquid like water (drinking water,
perspiration, seawater, urine of pet animals, etc.) or dust to
the terminal.
・
While microSD card is being used, do not take the card out
or do not turn off the terminal.
- May cause data loss or malfunction.
・
Do not bring magnetic cards etc. close to the terminal.
- Magnetic data in cash cards, credit cards, telephone cards,
floppy disks, etc. may be erased.
・
Do not bring magnetized objects close to the terminal.
- Bringing strong magnetism close may cause a
malfunction.
17
Contents/Precautions