Fujitsu Arrows NX F-01J Instruction Manual page 129

･
If more than one Wi-Fi network has been saved, you can
switch from one network to another by selecting the
destination network and then tapping [CONNECT]. The Wi-Fi
network you are currently connected to is disconnected and
the network automatically switches to the selected Wi-Fi
network.
* Even after you are disconnected from the network, its
information will remain on the terminal. You can
reconnect to the network by performing the connecting
operation.
◆ Scanning Wi-Fi network
･
Set Wi-Fi to ON in advance.
1
From the Home screen,
& Bluetooth]→[Easy Settings/Select network]
2
[MENU]→[Update]
◆ Adding Wi-Fi network
Enter network SSID or security information to add Wi-Fi
network manually.
･
Set Wi-Fi to ON in advance.
1
From the Home screen,
& Bluetooth]→[Easy Settings/Select network]
2
[MENU]→[Add network]
3
Enter a network SSID of Wi-Fi network to add
→Select security
･
Security can be set to [None], [WEP], [WPA/WPA2 PSK]
or [802.1x EAP].
→[Settings]→[Wi-Fi
→[Settings]→[Wi-Fi
127
4
Enter additional security information as
required→[SAVE]
◆ Deleting Wi-Fi network connecting
information
1
From the Home screen,
& Bluetooth]→[Easy Settings/Select network]
2
Select the connected Wi-Fi network→
[FORGET]
◆ Wi-Fi Easy Settings
You can connect through simple operations when connecting
via a Wireless access point supporting AOSS™ and WPS
connection.
･
Set Wi-Fi to ON in advance.
1
From the Home screen,
& Bluetooth]→[Easy Settings/Select network]
2
[EASY SETTINGS]
3
Select a registration method
AOSS™ system : [AOSS system]→Tap [AOSS] button→
Perform operations on the access point →On the
connection complete screen, [Finish]
WPS system : [WPS system]→[Push button system]/[PIN
entry system (8 digits)]/[PIN entry system (4 digits)]→
Perform necessary operations on the access point
･
In case of push button method, press a dedicated button
on an access point. In case of PIN entry method, enter
→[Settings]→[Wi-Fi
→[Settings]→[Wi-Fi
Settings