Fujitsu Arrows NX F-01J Instruction Manual page 149

◆ Personal assist
Personal assist learns how you usually use the terminal, based
on information such as the location, time, and day of the week.
You can set up this feature to display a list of candidate
applications for your convenience.
･
Turn Personal assist on to allow it to start learning how you
usually use the terminal. When the learning process is
complete, Personal assist is displayed on the Home screen.
Note that it may take several days for the learning process to
be completed.
1
From the Home screen,
tools]→[Personal assist]
2
Set [Personal assist] to ON
･
Tap [Function description] to see detailed information
about Personal assist and instructions for using it.
3
Operate following onscreen instructions→
[START USING]
✔INFORMATION
･
Configure the following settings to use Personal assist more
comfortably. These settings will help identify your current
location with higher accuracy, thus providing more accurate
assistance. Also, you can use Wi-Fi to identify even an indoor
location where the GPS function does not work.
- Set [Location data/GPS] to ON, and set the mode to [High
accuracy]→P113
- Set [Wi-Fi] to ON→P126
- From the Home screen,
[Location data/GPS]→[MENU]→[Scanning]→Set [Wi-Fi
scanning] to ON
→[Settings]→[Useful
→[Settings]→[Useful tools]→
◆ FM transmitter
You can transmit music saved in the terminal via FM radio
waves to listen from an FM radio or car stereo system.
･
FM transmitter is unavailable while the docomo nano UIM
card is not installed.
･
To improve signal reception, extend the TV/FM transmitter
antenna fully, and put the terminal close to the FM radio or
turn the antenna around.→P94
1
From the Home screen,
tools]→[FM transmitter]
2
Set [FM transmitter] to ON→[OK]
3
[Radio frequency]→Select a radio frequency
4
Tune to the frequency on the receiver
✔INFORMATION
･
FM transmitter cannot be turned on while the terminal is in
the following status. If the terminal is in the following status
when FM transmitter is ON, FM transmitter turns off
automatically.
- While in Airplane mode, when Bluetooth is ON, when
earphones are connected, during Miracast output, and
during international roaming
- When you have never entered the service area since the
terminal was ON
･
You cannot turn the FM transmitter on when receiving a call
or during a voice call. Also, although you can receive calls
and have voice calls when the FM transmitter is turned on,
the transmitter will not output voice.
147
→[Settings]→[Useful
Settings