Fujitsu Arrows NX F-01J Instruction Manual page 190

- When the remaining battery is not sufficient
- When the terminal is low on available memory
- When the basic software is altered
･
Exit from all applications before installing.
･
Update software when the terminal battery is fully charged.
･
Do not turn off the terminal while updating.
･
It is recommended that this terminal be put in a place with
good reception and not be moved while downloading. The
update may stop when it is put in a place with bad reception.
･
When it does not need to update, "No upgrade is needed.
Use it as it is." appears.
･
For details about updating available period, refer to NTT
DOCOMO website.
◆ Updating software
･
When the terminal needs to update, you are required to
perform the installation. Open the Notification panel→Tap
the notification→[Install].
■ Changing the automatic download setting
1
From the Home screen,
[Device management]→[About phone]→
[Software Update]→Tap the "Auto download"
button and set to ON/OFF
･
When "Auto download" is set to OFF, operate "When the
icon is not displayed on status bar" (→P188).
→[Settings]→
188
■ When the icon is not displayed on the status bar
Perform the update by the following operations.
1
From the Home screen,
[Device management]→[About phone]→
[Software Update]→[Update now]
Downloading starts.
2
When the message to start the installation
appears, tap [OK]/[Install].
･
Depending on the update contents, the confirmation
screen about updating appears after tapping [Update
now].
･
When the confirmation screen appears, follow the
procedure below.
a Select an upgrade method
Perform now (only via Wi-Fi) : Immediately download
the update file via Wi-Fi connection.
Perform at scheduled time (via Wi-Fi/Xi) : Via Wi-Fi
connection or Xi/FOMA, the update file will be
downloaded automatically at the reserved time.
･
If download via Xi/FOMA is not available, [Perform at
scheduled time (only via Wi-Fi)] appears. When the
sp-mode is not set, the update cannot be performed
by tapping [Perform at scheduled time (only via Wi-
Fi)]. Use Wi-Fi.
→[Settings]→
Appendix/Index