Fujitsu Arrows NX F-01J Instruction Manual page 35

■ Removing
a Face up the display side of the terminal and open the slot
cap hooking the groove with your fingertip
b Put your fingertip on the groove of the tray and pull it
straight out, then remove the docomo nano UIM card
c Make sure that the display side of the terminal is facing
down, then insert the tray straight into the docomo nano
UIM card slot
d Press firmly the slot cap of the terminal to close→P26
✔INFORMATION
･
When handling docomo nano UIM card, take care not to
touch or scratch the IC. Also, be aware that trying to insert or
remove the docomo nano UIM card using excessive force
may cause it to break.
･
For removing/inserting the tray from/into the docomo nano
UIM card slot, do not remove or insert forcibly. Doing so may
damage the tray.
･
IMEI sheet with IMEI number and bar code printed is inserted
under the docomo nano UIM card slot. Do not pull out the
IMEI plate because it will be requested at a DOCOMO-
specified repair office when the terminal is damaged etc.
Also, please note the following.
- If you pull out the IMEI sheet accidentally, insert it.
- Do not pull out the IMEI sheet forcibly because it may cause
damage.
- If you lost the IMEI sheet, repairs may be refused.
◆ Security code for the docomo nano
UIM card
You can set up a security code called a PIN code for your
docomo nano UIM card. At the time of subscription, the code
is set to "0000", which you can change by yourself.→P143
33
Before using the terminal