Cartridge Position Adjustment - Roland Color Camm Pro PC-60 Service Notes

4-14 CARTRIDGE POSITION ADJUSTMENT

CARTRIDGE POSITION ADJUSTMENT is designed to align the relative positions of HEAD
CARRIAGE and the CARTRIDGE HOLDER for proper cartridge pick when HEAD enters the
CARTRIDGE HOLDER to pick the cartridge.
This adjustment must be performed after replacement of the HEAD CARRIAGE, CARTRIDGE HOLDER
and MAIN BOARD.
It is necessary to enter the CARTRIDGE POSITION ADJUSTMENT MODE in the FACTORY MODE to
perform this adjustment.
[CARTRIDGE POSITION ADJUSTMENT MODE FLOW CHART (in Factory Mode)]
[POWER] LED will blink and
[PIECE] & [ROLL] LED will be ON
ADJUSTMENT
MODE
[ ] or [ ] keys
Adjust CARTRIDGE
POSITION.
[SHEET TYPE] key
Save Settings.
Remove the RAIL COVER and open the FRONT COVER..
1
CARTRIDGE POSITION
ADJUSTMENT MODE
[POWER] LED will be ON and
[PIECE] LED will blink.
[POWER] key
CARTRIDGE
EXCHANGE
TEST
Open FRONT COVER.
Performs CARTRIDGE
EXCHANGE TEST.
[POWER] LED will be ON and
[ROLL] LED will blink.
[SHEET TYPE] key
CMYK SENSING
TEST
ERROR
Performs CMYK
SENSING TEST.
END
4 Adjustment
4
Close FRONT COVER.
GOOD
67