Head Position Adjustment 2 - Roland Color Camm Pro PC-60 Service Notes

4-12 HEAD POSITION ADJUSTMENT 2

HEAD POSITION ADJUSTMENT 2 is designed to ensure the printing quality by aligning the HEAD to be
vertical to the GUIDE RAIL It is necessary to avoid BROKEN RIBBON and TWISTED RIBBON.
This adjustment must be performed after replacement of the HEAD CARRIAGE.
Remove the RAIL COVER and raise the SHEET
1
LOADING LEVER.
Enter the TEST PATTERN MODE by turning on the SUB
2
POWER SW while pressing [
keys.
Select [3 mm pitch straight line] with [BASE POINT] or
[CUT TEST] key.
Put the BLACK RIBBON CARTRIDGE to the
3
CARTRIDGE HOLDER and set the MEDIA.
Other RIBBON CARTRIDGE except the
BLACK can not be used.
], [ ] and [CUT TEST]
TEST PATTERN
NO.1 NO.2
3mm pitch straight line
OFF OFF
Dithering Test Pattern ON OFF
100% Dithering Pattern OFF ON
Slanting Parallel Line ON ON
Solid Color Test Pattern with
ON OFF
bottom half of Head
Solid Color Test Pattern with
OFF ON
top half of Head
Checker ON ON
4 Adjustment
CARTRIDGE HOLDER LED
NO.3 NO.4 NO.5 NO.6
OFF OFF OFF OFF
OFF OFF OFF OFF
OFF OFF OFF OFF
OFF OFF OFF OFF
ON OFF OFF OFF
ON OFF OFF OFF
ON OFF OFF OFF
63
4