Roland Color Camm Pro PC-60 Service Notes page 51

Put the WHITE DUMMY PEN (ST-006) to the TOOL
2
CARRIAGE.
Turn on the MAIN POWER SW while pressing [POWER],
3
[SHEET TYPE] and [BASE POINT] keys and enter the
FACTORY MODE.
Select [CARTRIDGE HOLDER 2] with [
and press [SHEET TYPE] key to enter the TOOL
PRESSURE ADJUSTMENT MODE.
Move the TOOL CARRIAGE to the 3 positions shown in
4
the figure.
Carry out the procedure mentioned in 5 at the position where
the clearance between the pen tip and the BED is the
smallest among the 3.
Adjust the ADJUSTING SCREW so that the clearance
5
between the pen tip and the BED would be 2.4—2.6 mm.
ST-006
] or [ ] keys
ADJUSTING SCREW
4 Adjustment
CARRIAGE ASSEMBLY
To enter
For selection
BED
4
47