3 Replacement of Main Parts
Following table describes the necessary adjustment after the replacement of each parts.
Replacement Parts
MAIN BOARD
HEAD CARRIAGE
TOOL CARRIAGE
CARTRIDGE HOLDER
WIRE
3-1 HEAD CARRIAGE ASSEMBLY_QUICK REPLACEMENT
This section explains the procedure for replacing the HEAD CARRIAGE simply and efficiently.
Therefore, there are some screws on the HEAD CARRIAGE which should not be touched. In case
you have touched this screw, fix the HEAD CARRIAGE by refering to 3-2 HEAD CARRIAGE
ASSEMBLY_REPLACEMENT.
Remove the RAIL COVER and disconnect the HEAD
1
CABLEs connected to CARRIAGE BOARD.
Necessary Adjustment
Initialization, Head Voltage Adjustment, Cartridge Position Adjustment, Print/Cut
Offset Adjustment, Tool Pressure, Grit Compensation, Thermal Head Density
Adjustment
Head Voltage Adjustment, Head Density Adjustment, Cartridge Position
Adjustment, Head Position Adjustment, Print/Cut Offset Adjustment, Printed Length
Initialization
Tool Height Adjustment, Tool Pressure Adjustment, Print/Cut Offset Adjustment
Cartridge Position Adjustment
Wire Tension Adjustment
3 Replacement of Main Parts
3
19