Roland Color Camm Pro PC-60 Service Notes page 75

Turn on the MAIN POWER SW while pressing [POWER],
2
[SHEET TYPE] and [BASE POINT] keys and enter the
FACTORY MODE.
Select [CARTRIDGE HOLDER 6] with [
and press [SHEET TYPE] key to enter the CARTRIDGE
POSITION ADJUSTMENT MODE.
Make sure that it is in the TEST MODE.
3
During the TEST MODE, [POWER] LED will be ON and
either [PIECE] or [ROLL] LED will blink.
If not, press the [POWER] key to enter the MODE.
Select CMYK SENSING CHECK.
4
Selection can be done by [SHEET TYPE] key.
[PIECE] LED blinks : CARTRIDGE EXCHANGE
[ROLL] LED blinks : CMYK SENSRING CHECK
Put CMYK ribbon in the CARTRIDGE HOLDER and close
5
the FRONT COVER.
PC60 starts performing CARTRIDGE EXCHANGE in order
of CMYK.
] or [ ] keys
TEST
4 Adjustment
To enter
For selection
4
71