4 Adjustment
4-16 GRIT COMPENSATION
GRIT COMPENSATION is designed to ensure the distance accuracy by adjusting the media-feeding rate.
This adjustment must be performed after replacement of the MAIN BOARD, or in case of having GAP
between BANDs or BANDING PROBLEM, or in case you like to improve the distance accuracy.
It is necessary to enter the GRIT COMPENSATION MODE in the FACTORY MODE to perform this
adjustment.
[GRIT COMPENSATION MODE FLOW CHART (in Factory Mode)]
4
Indicates setting by
LED.
Make sure to check the followings before this adjustments.
1
1. Put LINE SPACING MODE to default. (P.95)
2. Put the GRIT ECCENTRICITY ADJUSTMENT to
default.
72
[POWER] LED will blink and
[PIECE] & [ROLL] LED will be ON.
[CUT TEST] key
[BASE POINT] key
Change parameters
to default.
After all [CARTRIDGE HOLDER] LED
become ON, it will be turned OFF from 1 to 6 in order.
Then, [PIECE] and [ROLL] LED will be ON.
ADJUSTMENT MODE
[
] or [
] keys
Change parameters
for GRIT
COMPENSATION.
[
] or [
] keys
[SHEET TYPE] key
Save Settings.
GRIT COMPENSATION
MODE
[POWER] key
PRINTING MODE
Test pattern for GRIT
COMPENSATION will
be printed.