4-13 PRINT/CUT OFFSET ADJUSTMENT
PRINT/CUT OFFSET ADJUSTMENT is designed to ensure the relation of printing and cutting position.
This adjustment must be performed after replacement of the TOOL CARRIAGE, HEAD CARRIAGE and
MAIN BOARD. It is necessary to enter the PRINT/CUT OFFSET ADJUSTMENT MODE in the
FACTORY MODE to perform this adjustment.
[PRINT/CUT OFFSET ADJUSTMENT MODE FLOW CHART (in Factory Mode)]
[POWER] LED will be ON and
[PIECE] or [ROLL] LED will blink.
[POWER] LED will blink and
[PIECE] & [ROLL] LED will be ON.
After all [CARTRIDGE HOLDER] LED
become ON, it will be turned OFF from 1 to 6 in order.
Then, [PIECE] and [ROLL] LED will be ON.
Raise the SHEET LOADING LEVER.
1
PRINT/CUT OFFSET ADJUSTMENT MODE
Set media and
ribbon cartridge.
CROP MARK will
be printed.
Adjust PRINT/CUT
OFFSET.
Save Settings.
[POWER] key
[
], [
], [
] and [
] keys
[SEET TYPE] key
4 Adjustment
4
[POWER] key
65