Roland Color Camm Pro PC-60 Service Notes page 25

Tighten the ADJUSTING SCREW B so that HEAD
4
CARRIAGE would be parallel to the GUIDE RAIL.
And tighten up SCREW B.
Connect the HEAD CABLEs to the CARRIAGE BOARD
5
and secure them with INSULOCK TIE.
Make sure not to fold the HEAD CABLE
completely. It may cause cut-line.
Carry out the following adjustments.
6
1. HEAD VOLTAGE ADJUSTMENT
2. HEAD DENSITY ADJUSTMEJNT
3. CARTRIDGE POSITION ADJUSTMENT (1st)
4. HEAD POSITION ADJUSTMENT 2
5. CARTRIDGE POSITION ADJUSTMENT (2nd)
6. PRINT/CUT OFFSET ADJUSTMENT
7. PRINT LENGTH INITIALIZE
Try printing test. If you have twisted ribbon, carry out
7
HEAD POSITION ADJUSTMENT 1.
ADJUSTING SCREW B
NG
3 Replacement of Main Parts
SCREW B
3
GOOD
21