Line Spacing Adjustment Mode - Roland Color Camm Pro PC-60 Service Notes

AUTO POWER OFF MODE
Auto Power OFF function is to turn off the SUB POWER when PC-60 doesn't receive any command for 1 hour. This function can be
disabled by turing bit#10 of the DIP SW.

7-3 LINE SPACING ADJUSTMENT MODE

Following table describes the procedure to adjust the LINE SPACING for users.
How to Correct Line Pitch
1. Hold down the [BASE POINT] key on the panel while you turn the POWER key (sub power) on.
2. Pressing the [
] and [
3. Referring to the table below, use the
(Offset can only be used for narrow line pitch than the default value, which is no offset.)
* Distance accuracy cannot be guaranteed when line-pitch correction has been performed.
4. The setting is completed when the [POWER] key is used to switch off the sub power.
] keys changes the displayed [CARTRIDGE HOLDER] LEDs.
[ ] and [
Flashing
CARTRIDGE HOLDER LED
6
5
4
3
2
1
keys to determine the amount of offset between line.
]
Pitch
(corresponding number of dots)
Default (no offset)
-0.5
-1.0
-1.5
-2.0
-2.5
7 Supplement
7
95