Roland Color Camm Pro PC-60 Service Notes page 28

3 Replacement of Main Parts
Adjust the position of the HEAD CARRIAGE so that the
9
RESIN part on the HEAD CARRIAGE makes contact with
the PLATE. Then tighten SCREW C.
3
Tighten the ADJUSTING SCREW B so that HEAD
10
CARRIAGE would be parallel to the GUIDE RAIL.
And tighten up SCREW B.
Connect the HEAD CABLEs to the CARRIAGE BOARD
11
and secure them with INSULOCK TIE.
Make sure not to fold the HEAD CABLE
completely. It may cause cut-line.
Carry out the following adjustments.
12
1. HEAD VOLTAGE ADJUSTMENT
2. HEAD DENSITY ADJUSTMENT
3. CARTRIDGE POSITION ADJUSTMENT (1st)
4. HEAD POSITION ADJUSTMENT 1
5. HEAD POSITION ADJUSTMENT 2
6. CARTRIDGE POSITION ADJUSTMENT (2nd)
7. PRINT/CUT OFFSET ADJUSTMENT
8. PRINT LENGTH INITIALIZE
24
SCREW C
ADJUSTING SCREW B
NG
SCREW B
GOOD