Roland Color Camm Pro PC-60 Service Notes page 53

Turn on the MAIN POWER SW while pressing [POWER],
2
[SHEET TYPE] and [BASE POINT] keys and enter the
FACTORY MODE.
Select [CARTRIDGE HOLDER 2] with [
and press [SHEET TYPE] key to enter the TOOL
PRESSURE ADJUSTMENT MODE.
Select MAX. MODE.
3
MAX. and MIN. can be selected by pressing the [BASE
POINT] key. Then, move the SLIDE VOLUME for TOOL
PRESSURE at the right side of the machine to MAX.
MAX. MODE : [CARTRIDGE HOLDER] LED ON
MIN. MODE : [CARTRIDGE HOLDER] LED OFF
Move the TOOL CARRIAGE to the position where the
4
TOOL HIGHT has been adjusted by hand.
Press [CUT TEST] key to move the tool down.
Pull up the TOOL CARRIAGE with the TENSION GAUGE
5
(ST-002) and measure the TOOL PRESSURE when the pen
tip leaves the BED.
Adjust TOOL PRESSURE so that it will be 195—205gf
with [ ] and [ ] keys.
Press the [SHEET TYPE] key to save the settings.
] or [ ] keys
ST-002
4 Adjustment
To enter
For selection
CARRIAGE
ASSEMBLY
BED
4
49