Roland Color Camm Pro PC-60 Service Notes page 85

Make sure to check the followings before this adjustment.
1
1. Put LINE SPACING MODE to default. (P.95)
2. GRIT CALIBRATION
3. Turn off the FRONT EDGE SENSE MODE. (P.94)
Raise the SHEET LOADING LEVER.
2
Turn on the MAIN POWER SW while pressing [POWER],
[SHEET TYPE] and [BASE POINT] keys and enter the
FACTORY MODE.
Select [CARTRIDGE HOLDER 4] with [
and press [SHEET TYPE] key to enter the GRIT
ECCENTRICITY ADJUSTMENT MODE.
Set the CYAN RIBBON CARTRIDGE and MEDIA on the
3
machine. And then, select ROLL as media type.
Other RIBBON CARTRIDGE except the CYAN
can not be used.
Lower the SHEET LOADING LEVER and close the
4
FRONT COVER.
The pattern shown in the figure will be printed.
Because there is no STITCHING TREATMENT,
there will be gap or banding between bands.
] or [ ] keys
30mm
4 Adjustment
To enter
For selection
17 BANDs
30mm
4
17 BANDs
81