Roland Color Camm Pro PC-60 Service Notes page 62

4 Adjustment
Raise the SHEET LOADING LEVER
2
Keep pressing the [POWER] key until [POWER] and
[FRONT COVER] LED start blinking to enter the
STITCHING ADJUSTMENT MODE.
4
Press [CUT TEST] key to enter the MANUAL
3
ADJUSTMENT MODE.
During this mode, [COLOR] LED will be ON.
Reset the settings for THERMAL HEAD DENSITY
4
ADJUSTMENT to 0.
To enter the RESET MODE, press [
[CARTRIDGE HOLDER LED 1, 3 & 5] and
[CARTRIDGE HOLDER LED 2, 4 & 6] will blink
alternately.
To carry out, press [SHEET TYPE] key.
Select GROUP SELECTION MODE.
5
Selection can be done by [BASE POINT] key.
[BASE POINT] LED ON : GROUP SELECTION MODE
[BASE POINT] LED OFF : SETTING MODE
58
] key.