Roland Color Camm Pro PC-60 Service Notes page 82

4 Adjustment
[THERMAL HEAD DENSITY ADJUSTMENT MODE FLOW CHART (in Factory Mode)]
Send data from PC.
[SHEET TYPE] key
Reset parameters
to default.
[CARTRIDGE HOLDER 1, 3 & 5] and
[CARTRIDGE HOLDER 2, 4 & 6] will
blink alternately.
4
Turn on the MAIN POWER SW while pressing [POWER],
1
[SHEET TYPE] and [BASE POINT] keys and enter the
FACTORY MODE.
Select [CARTRIDGE HOLDER 5] with [
and press [SHEET TYPE] key to enter the THERMAL
HEAD DENSITY ADJUSTMENT MODE.
Raise the SHEET LOADING LEVER
2
Keep pressing the [POWER] key until [POWER] and
[FRONT COVER] LED start blinking to enter the
STITCHING ADJUSTMENT MODE.
78
THERMAL HEAD DENSITY
[CUT TEST] key
[COLOR] LED will be ON.
AUTO. ADJUSTMENT
MODE
[ ] key
RESET MODE
[BASE POINT] LED will
be OFF.
[BASE POINT] key
SETTING MODE
[ ] or [ ] keys
Change parameters
for HEAD DENSITY.
[SHEET TYPE] key
Save Settings.
] or [
ADJUSTMENT MODE
[POWER] key
STITCHING
ADJUSTMENT
MODE
[CUT TEST] key
MANUAL
STITCHING ADJUSTMENT
ADJUSTMENT
for TOP EDGE.
MODE
[BASE POINT] key [ ] or [
[BASE POINT] LED will
be ON.
GROUP
Change parameters for TOP
SELECTION
STITCHING ADJUSTMENT.
MODE
[SHEET TYPE] key
[ ] or [ ] keys
Select GROUP to
Save Settings.
be adjusted.
] keys
[POWER] & [FRONT COVER] LED
[POWER] & [BASE POINT] LED
will blink.
will blink.
[ ] key
STITCHING ADJUSTMENT
for BOTTOM EDGE.
[ ] key
] keys
Change parameters for BOTTOM
STITCHING ADJUSTMENT.
Save Settings.
After all [CARTRIDGE HOLDER] LED
become ON, it will be turned OFF from 1 to 6 in order.
Then, [PIECE] and [ROLL] LED will be ON.
To enter
For selection
[ ] or [ ] keys
[SHEET TYPE] key