Roland Color Camm Pro PC-60 Service Notes page 24

3 Replacement of Main Parts
Remove SCREW B and ADJUSTING SCREW B. Then,
2
remove the HEAD CARRIAGE by pulling it upwards.
Make sure not to touch the SCREW A and
ADJUSTING SCREW A. In case you have touched
these screws, carry out 3-2 HEAD CARRIAGE
ASSEMBLY_REPLACEMENT.
3
Remove the HEAD HOLDER together with the ADAPTER
3
by removing the 3 SET SCREWs shown in the figure.
Do not loosen SCREW C. In case you have loosen
these screws, carry out 3-2 HEAD CARRIAGE
ASSEMBLY_REPLACEMENT.
Fix the HEAD HOLDER together with the ADAPTER to
4
the HEAD CARRIAGE.
Put the HEAD CARRIAGE so that the PLATE comes
5
between the RESIN part and also the HOLE in the HEAD
HOLDER will be positioned to the projected part on the
CARRIAGE BASE. Then tighten the ADJUSTING
SCREW B and SCREW B temporary.
Make sure to put the SPRING to the left side of the
HEAD CARRIAGE.
20
ADJUSTING SCREW B
DO NOT TOUCH
SCREW A
SCREW B
ADAPTER
SCREW C
SET SCREW
ADAPTER
SET SCREW
ADJUSTING SCREW B
PLATE
SPRING
SCREW B
ADJUSTING SCREW A
SCREW B
HEAD
HOLDER
SCREW C
HEAD
HOLDER
HOLE FOR POSITIONING
RESIN PART
SCREW B