Overview; Safety Messages - Emerson Rosemount 4600 Reference Manual

Reference Manual
00809-0100-4022, Rev GA
Section 5
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 47
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 47
5.1

Overview

Table 5-1
common operating problems.
If you suspect malfunction despite the absence of any diagnostic messages on the Field
Communicator display, follow the procedures described here to verify that transmitter
hardware and process connections are in good working order. Always deal with the most
likely checkpoints first.
5.2

Safety messages

Procedures and instructions in this section may require special precautions to ensure the
safety of the personnel performing the operations. Information that raises potential safety
issues is indicated by a warning symbol ( ). Refer to the following safety messages before
performing an operation preceded by this symbol.



Static electricity can damage sensitive components.

Troubleshooting
www.aotewell.com
Troubleshooting
provides summarized maintenance and troubleshooting suggestions for the most
Transmitters located in hazardous areas should be installed in accordance with local
codes and requirements for that area.
Use appropriately rated Ex adapters, blanking elements, and glands during
installation.
Keep process insulation at least 1-in. [25 mm] from transmitter connection.
Observe safe handling precautions for static-sensitive components.
sales@aotewell.com
Industry Automation
Troubleshooting
September 2016
47
+86-755-8660-6182