Diagnostics And Service - Emerson Rosemount 4600 Reference Manual

Configuration
September 2016
AMS Device Manger
Right click on the device and select Configuration Properties from the menu
1.
2.
3.
4.
5.
6.
2.8.7 Sensor temperature unit
Fast Keys
The Sensor Temperature Unit command selects between Celsius and Fahrenheit units for the
sensor temperature. The sensor temperature output is accessible via HART only.
AMS Device Manger
Right click on the device and select Configuration Properties from the menu.
1.
2.
3.
4.
5.
2.9

Diagnostics and service

Diagnostics and service functions listed below are primarily for use after field installation. The
Transmitter Test feature is designed to verify that the transmitter is operating properly, and can
be performed either on the bench or in the field. The Loop Test feature is designed to verify
proper loop wiring and transmitter output, and should only be performed after you install the
transmitter.
16
www.aotewell.com
In the Analog Output tab, locate the Configuration Pressure Alerts box, enter Press Hi Alert
Val and Press Lo Alert Val to configure the pressure alerts.
Configure Press Alert Mode to ON or OFF the drop down menu.
In the Configuration Temperature Alerts box, enter Temp Hi Alert Val and Temp Lo Alert Val
to configure the temperature alerts.
Configure Temp Alert Mode to ON or OFF using the drop down menu and select Apply.
An Apply Parameter Modification screen appears, enter desired information and select
OK.
After carefully reading the warning provided, select OK.
1, 4, 1, 2, 2
In the Process Input tab, use the drop down menu Snsr temp unit to select F (Farenheit)
or C (Celsius). Select Apply.
Select Next to acknowledge send warning.
Select Finish to acknowledge the method is complete.
An Apply Parameter Modification screen appears, enter desired information and select
OK.
After carefully reading the warning, select OK.
sales@aotewell.com
Industry Automation
Reference Manual
00809-0100-4022, Rev GA
.
Configuration
+86-755-8660-6182