Overview; Safety Messages - Emerson Rosemount 4600 Reference Manual

Reference Manual
00809-0100-4022, Rev GA
Section 3
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 25
General considerations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 26
Mechanical considerations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 26
Installation procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 28
Hazardous locations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 32
Grounding the transmitter case . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 33
3.1

Overview

The information in this section covers installation considerations. A Quick Start Guide
(document number 00825-0100-4022) is shipped with every transmitter to describe basic
mounting and wiring procedures for initial installation.
Field Communicator and AMS
perform configuration functions. For convenience, Field Communicator Fast Key sequences
are provided and labeled "Fast Keys" for each software function below the appropriate
headings.
3.2

Safety messages

Procedures and instructions in this section may require special precautions to ensure the
safety of the personnel performing the operation. Information that raises potential safety
issues is indicated with a warning symbol (
before performing an operation preceded by this symbol.
Explosions can result in death or serious injury.



Electrical shock can result in death or serious injury.

Process leaks could result in death or serious injury.

Installation
www.aotewell.com
Installation
™
Transmitters located in hazardous areas should be installed in accordance with
local codes and requirements for that area.
Use appropriately rated Ex adapters, blanking elements, and glands during
installation.
Keep process insulation at least 1-in. (25 mm) from transmitter connection.
Avoid contact with the exposed leads and terminals. High voltage that may be
present on leads can cause electrical shock.
Properly tighten process connections before applying pressure.
sales@aotewell.com
Device Manager instructions are provided to allow users to
). Refer to the following safety messages
Industry Automation
Installation
September 2016
25
+86-755-8660-6182