Configuration Menu - Furuno FELCOM 70 Operator's Manual

5.9

Configuration menu

5.9.1 ISDN protocol configuration
1 Open the Configuration menu via the Function menu > Advanced
function menu>Configuration.
2 Double-clicking the ISDN configuration displays the ISDN configurations
implemented in FELCOM 70.
3 Press the up or down arrow key to select a item and the right arrow key to
show the selection dialog box.
Switch to owner level to choose protocol.
• Protocol
Select Euro ISDN for connection of equipment conforming to the European
ISDN standard. (NI-1 can not be used.) Select same protocol for all ISDN
handsets and PC.
• Date/time element
When enabled, date and time is sent to the connected Terminal Equipment
during call establishment some ISDN devices do not survive this message.
The date and time transmission may then be disabled.
• Layer 2 Activation
The layer 2 connection is deactivated after some idle time as default. Some
ISDN devices interpret this as an alarm situation. Layer 2 deactivation can
then be disabled.
• Default service
Some ISDN devices can not
signal their own MSN number.
Such a phone will be able to use
the 64 kbps service since all
"unknown" speech devices are
required to use the 4.8 kbps
speech service. The user can set
FELCOM 70 to map all
"unknown" devices to 64 kbps
speech service.
Note: Remember to revert to
user level.
5. CONFIGURATION FROM PC
1
Exit Menu 1. Set default
Net provider
Mail
Exit Menu
Exit Menu
8. Change
tone
2
2. Set access 4. Phone 9. advanced
level setup menu functions
1. Access 3. Software 4. Alarms
7.
control updata prep. and messages
Configuration
2. Net service 4. Set
1. ISDN 7. RxL-Band
providers diagnostics
configuration Setup
9. Spot Beme
Report Method
5-17