Analogue Telephone - Furuno FELCOM 70 Operator's Manual

2. OPERATION FROM HANDSET
2.16

Analogue telephone

Outgoing call
1 Lift handset and receive dial tone
2 Dial the subscriber number (and #)
3 When finished, replace the handset
Redialing
If the subscriber is busy, or you want to make a new call to the last dialled
subscriber, you can lift the handset, receive new dial tone and then press the
[REPETER] button.
Note that this button is for manually dialled numbers only. Stored numbers will
not be repeated using this method.
Storing abbreviated numbers
Ten subscriber numbers can be stored in the telephone's memory in short from.
The numbers can be used for outgoing call, by pushing 2 buttons only.
1 Lift handset and press [LAGRE/SEKR] button (Don't worry the dial tone)
2 Press [MINNE] button.
3 Select relevant storing address by pushing one button.(0 - 9)
4 Dial the subscriber no. and # (max. 21 digits).
5 Press [LAGRE/SEKR] button.
6 Replace handset. The number is stored.
7 Repeat the step 1 - 6 to store additional numbers.
If required to change a number, just overwrite existing number.
2-12
1 Speaker
2 Keypads
3 R-button (not used)
4 Storing / Microphone
muting
5 Last number redial
6 Hook on / off
7 Line cable outlet
8 Microphone
9 Memory (stored numbers)
10 Volume control
11 Ringing signal High / Low