Connecting To 1000Base-T Sfp Modules - Cisco Catalyst 3750 Hardware Installation Manual

Chapter 2 Switch Installation
If necessary, reconfigure and restart the switch or target device.
Step 5
For detailed instructions on removing the SFP modules, see your SFP documentation.
Caution

Connecting to 1000BASE-T SFP Modules

Follow these steps to connect a Category 5 cable to a 1000BASE-T SFP module port (see
To prevent ESD damage, follow your normal board and component handling procedures.
Caution
When connecting to servers, workstations, and routers, insert a four twisted-pair, straight-through cable
Step 1
in the RJ-45 connector. When connecting to switches or repeaters, insert a four twisted-pair,
crossover cable.
When connecting to a 1000BASE-T device, be sure to use a four twisted-pair, Category 5 cable.
Note
Figure 2-57
13 X
14 X
1
Insert the other cable end in an RJ-45 connector on a target device.
Step 2
Observe the port status LED.
Step 3
The LED turns green when the switch and the target device have an established link.
The LED turns amber while the STP discovers the network topology and searches for loops. This process
takes about 30 seconds, and then the port LED turns green.
OL-6336-06
Connecting to an SFP Module Port
13
14
15
16
17
18
19
20
21
22
23
24
1
RJ-45 connector
C a ta ly s t
3 7 5 0
S E R IE S
23 X
1
24 X
2
Catalyst 3750 Switch Hardware Installation Guide
Connecting to an SFP Module
Figure 2-57):
2-45