Connecting To 1000Base-T Sfp Modules - Cisco Catalyst 2970 Hardware Installation Manual

Chapter 2 Switch Installation
Step 5

Connecting to 1000BASE-T SFP Modules

Caution
OL-6422-01
If the LED is off, the target device might not be turned on, there might be a cable
problem, or there might be problem with the adapter installed in the target device.
See Chapter 3, "Troubleshooting,"
Figure 2-24 Connecting to a Fiber-Optic SFP Module Port
24
23
24
1 1
1
LC connector
If necessary, reconfigure and restart the switch or target device.
Follow these steps to connect a Category 5 cable to a 1000BASE-T SFP module:
To prevent ESD damage, follow your normal board and component handling
procedures.
for solutions to cabling problems.
C a ta ly s t 2
9 7 0
S E R IE S
25
26
27
28
Catalyst 2970 Switch Hardware Installation Guide
Connecting to SFP Modules
2-31