Headlight Housing Installation; Tail Light Service - Polaris RANGER XP 1000 2018 Service Manual

ELECTRICAL

HEADLIGHT HOUSING INSTALLATION

1. Install the headlight housing by pressing the housing
tabs back into the front fascia brackets.
2. Install the three Torx fasteners
Be sure to twist the O-rings upon installation as shown
3. Connect the harness to the bulb.
4. Adjust headlights. See Headlight Adjustment, page
11.21.
5. Install the front fenders. See Front Fender Service,
page 10.26.
6. Install the hood.
11.24
q
. Do not tighten.
NOTE
below.

TAIL LIGHT SERVICE

1. Open the rear tailgate.
2. Remove the two screws retaining the LED lamp
assembly.
3. Remove the LED lamp from the rear cargo box and
disconnect the tail light / brake light wire harness.
Before replacing the LED lamp assembly, use a digital
multi-meter to test the harness to ensure the lamp is
receiving 12 volts and that a ground path is present.
4. Install the new LED lamp assembly by reversing this
procedure.
5. Test the tail light / brake light after installation to verify
proper function.
9928487 R01 - 2018 RANGER XP 1000 Service Manual
NOTE
© Copyright Polaris Industries Inc.