Polaris RANGER XP 1000 2018 Service Manual page 345

6. Inspect the pinion shaft assembly. Replace bearings
if needed. Inspect each gear for damage, chips or
abnormally worn teeth.
NOTE
i
Item is directional and must have the beveled edge
face outward upon assembly.
IT-
E- DESCRIPTION
M
q Bearing
Retaining Ring
w
e
Washer
Gear (46T)
r
Bearing Cover Retaining
t
Screws (qty. 3)
y Snorkel Locking Screw
u Bearing Cover
i Retaining Ring
o Bearing
a
Pinion Shaft
NOTE
If pinion shaft was disassembled, the bearing cover
must be installed on the shaft before installing the 46T
gear.
7. Install the pinion shaft assembly. Be sure to properly
mesh the snorkel shaft bevel gear with the pinion
shaft bevel gear.
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
8. Apply Loctite® 242 to the threads of the bearing
cover retaining screws.
9. Install only the three screws that secure the pinion
shaft assembly as shown below. Leave the longer
locking screw
DO NOT install the longer screw
longer screw will lock the snorkel tube and not allow for
TORQUE (IF
APPLICA-
BLE)
10. Torque the bearing cover retaining screws to
—
specification.
—
—
—
9 ft-lbs (12
11. Temporarily install the RH case with a couple
Nm)
fasteners to hold the pinion shaft square to establish
a zero backlash starting point. Remove the RH case
9 ft-lbs (12
half once zero backlash starting point is established.
Nm)
12. Rotate the snorkel tube counterclockwise using the
—
snorkel tool (PU-52547) until the snorkel gear and
pinion gear have 'zero' backlash.
—
—
DO NOT overtighten the snorkel tube when backing it
—
out. At the 'zero' backlash position, you should still be
able to turn the snorkel shaft using your fingers, but it
will feel rough and may have some tight spots.
13. Look down into the transmission housing to see the
snorkel locking screw hole opening to reference your
starting point.
If you have a hard time seeing into the hole, insert a
small Allen wrench, punch or screwdriver into the hole
to feel when the notch is aligned with the hole.
TRANSMISSION
k
out at this point.
NOTE
k
. Installing the
backlash setting adjustment.
TORQUE
Bearing Cover Retaining Screws:
9 ft-lbs (12 Nm)
NOTE
NOTE
6
6.25