Polaris RANGER XP 1000 2018 Service Manual page 137

10. Use one of the oil pump retaining bolts or a pen
magnet to extract the dowel pins
pump. Doing so allows for oil pump removal without
having to remove the pump drive sprocket.
NOTE
If unable to extract the dowel pins from the oil pump,
the oil pump sprocket must be removed. Access the
sprocket bolt by removing the case plug.
11. Lift the oil pump drive chain and remove the oil pump.
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
12. Visually inspect the oil pump and drive sprocket
s
from the oil wear or damage. Replace oil pump drive chain and
sprocket if worn or damaged. If any part of the oil
pump is damaged, the entire assembly must be
replaced. Replace the oil pump seal
crankcase assembly.
13. Rotate the engine so the cylinder is facing up.
14. Remove the eleven M6
crankcase bolts.
15. Rotate the engine so the cylinder is facing down.
ENGINE / COOLING / EXHAUST
NOTE
Oil pump assembly is non-serviceable
g
and two M8
d
for
f
during
3
h
upper
3.45