Alternator Inspection/Replacement - Polaris RANGER XP 1000 2018 Service Manual

ENGINE / COOLING / EXHAUST
ALTERNATOR INSPECTION
1. Disconnect the negative (-) battery cable before
servicing the electrical system.
2. Inspect the electrical harness for cracks, abrasions
and damaged or corroded connectors. ALWAYS keep
the connectors and terminals clean.
3. Start the engine place the Digital Multimeter leads
between the power cable and a clean part of the
engine chassis. Ensure the voltage is within
specification.
Alternator Output: 14.4 ± 0.3 V
WARNING
Loose clothing, hair or other items can be caught in the
compressor drive belt. Take care not to allow loose
items to get caught in the moving compressor drive
3.116
belt.
ALTERNATOR REPLACEMENT
1. Disconnect the negative (-) battery cable before
servicing the electrical system.
2. Remove the compressor drive belt. Refer to
"Compressor Drive Belt Replacement", page
3.112 procedure.
3. Disconnect the wire harness connector and power
cable from the alternator.
4. Remove the alternator mounting fasteners.
5. For installation, reverse removal procedure.
6. Torque the alternator fasteners to specification in the
sequence as shown.
TORQUE
Alternator Mounting Fasteners:
37 lb-ft (50 Nm)
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.