Compressor Replacement; Compressor Oil Specifications - Polaris RANGER XP 1000 2018 Service Manual

ENGINE / COOLING / EXHAUST

COMPRESSOR REPLACEMENT

WARNING
In the event of a leak, wear safety goggles. Escaping
refrigerant can cause severe injuries to eyes. In contact
with a flame, R-134a refrigerant gives off a toxic gas.
1. Evacuate the refrigerant using an A/C recovery
system.
2. Remove the compressor drive belt. Refer to
"Compressor Drive Belt Replacement", page
3.112 procedure.
3. Disconnect the compressor clutch wire.
4. Remove the low pressure hose
compressor.
5. Remove the high pressure hose
compressor.
6. Cap and plug the compressor hoses and the fittings
with the proper A/C caps and plugs.
3.114
7. Remove the compressor mounting fasteners.
8. To install, reverse the procedure.
9. Recharge the A/C system.
q
from the

COMPRESSOR OIL SPECIFICATIONS

The compressor is factory filled with 150 - 170 cc's of
PAG 100 oil (Poly Alkelene Glycol).
It is only necessary to check, replenish or replace the
compressor oil in the following cases:
• When the evaporator, condenser or receiver-drier is
replaced.
• When refrigerant has leaked from the system.
• When refrigerant is suddenly released from the cooling
cycle.
• When any oil related problems occur in the cooling
cycle.
w
from the
When one of the components (the evaporator,
condenser or receiver-drier) is replaced, 1.0 ounce (30
cc) of PAG 100 oil should be added for each component
If the A/C compressor is changed, no oil should be
added to the system, because the compressor comes
Only PAG 100 oil should be used. Never mix R-12 and
TORQUE
Compressor Low Pressure Hose:
25 lb-ft (34 Nm)
Compressor High Pressure Hose:
18 lb-ft (24 Nm)
Compressor Mounting Fasteners:
37 lb-ft (50 Nm)
NOTE
replaced.
factory filled with oil.
R-134a Oils.
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.