Polaris RANGER XP 1000 2018 Service Manual page 349

CAUTION
Make sure torsion spring is installed correctly and the
cam snaps back into it's free state. If the torsion spring
is left out, or installed incorrectly, the shift into PARK
may not engage completely.
ITEM DESCRIPTION
o Retaining Clip
a
Washer
s Torsion Spring
d
Cam
f
Drum
12. Apply a continuous bead of Loctite® 680 Sealant
(PN: 3233901) to the left hand transmission mating
surface.
13. Install the transmission case cover and retaining bolts
g
. Torque bolts to specification.
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
TORQUE
Transmission Case Bolts:
20 ft-lbs (27 Nm)
NOTE
If using NEW left hand gearcase, holes are "not
threaded" for self tapping screws to form threads.
14. Install new seals into the transmission case halves.
h
• The snorkel shaft seal
until it seats against the housing counter-bore.
j
• The input shaft seal , should be pressed in until it
seats flush with the housing.
• The rear output shaft seals
using a standard bushing installation tool. Seals
should be installed just past the case lead-in
chamfer (.082" or 2.1 mm from outer face of bore).
15. Thoroughly clean the shift shaft housing.
IMPORTANT
Make sure the transmission is in HIGH gear prior to
reassembly
TRANSMISSION
, should be pressed in
k
, can be installed
6.29
6