Motorcycle Stationary - Engine Off
The ignition is switched ON.
▼
The engine stop switch is in the
▼
RUN position.
Motorcycle Stationary - Engine Running
Neutral gear is selected or the
▼
clutch is pulled in.
Motorcycle in Motion
Within 60 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
Close the throttle.
▼
Make sure that the brakes are not
▼
engaged (allow the motorcycle to
coast).
The riding mode selection is now
complete and normal riding can be
resumed.
Information Tray
Warning
When the motorcycle is in motion,
only attempt to switch between the
information tray modes or reset the
fuel information under the following
conditions:
- At low speed
- In traffic free areas
- On straight and level roads or
surfaces
- In good road and weather conditions.
Failure to observe this important
warning
could
motorcycle control and an accident.
lead
to
loss
of
GENERAL INFORMATION
The information tray appears in the top
section of the display screen for styles
01, 02 and 03. It appears on the left
hand side of the display screen for style
04. It allows easy access to different
motorcycle status information.
To view the different information tray
items, push the joystick left/right until
the required information tray item is
shown.
The
information
following information tray items:
Trip Meter, see page 64
▼
Fuel Status, see page 64
▼
Tire Pressure Monitoring System
▼
(TPMS) (if equipped), see page 65
Coolant, see page 65
▼
Service Interval, see page 65
▼
Brightness, see page 66
▼
Gear, see page 66.
▼
Different information tray items can be
shown or hidden from the information
tray. For further information, refer to
page 53.
tray
contains
the
63