Connecting To The L30 Relay - GE L30 Instruction Manual

1 GETTING STARTED
When unable to connect because of an "ACCESS VIOLATION," access Device Setup and refresh the order code for the
device.
1. Open the Display Properties window through the Site List tree as shown. The Display Properties window opens with a
status indicator on the lower left of the EnerVista UR Setup window.
2. If the status indicator is red, verify that the Ethernet network cable is properly connected to the Ethernet port on the
back of the relay and that the relay has been properly setup for communications (steps A and B earlier).
If a relay icon appears in place of the status indicator, than a report (such as an oscillography or event record) is open.
Close the report to re-display the green status indicator.
3. The Display Properties settings can now be edited, printed, or changed.
See chapter 4 in this manual or the EnerVista UR Setup Help File for information about the using the EnerVista UR
Setup software interface.
NOTE
QUICK ACTION HOT LINKS
The EnerVista UR Setup software has several quick action buttons to provide instant access to several functions that are
often performed when using L30 relays. From the online window, users can select the relay to interrogate from a pull-down
window, then click the button for the action they want to perform. The following quick action functions are available:
• View the L30 event record
• View the last recorded oscillography record
• View the status of all L30 inputs and outputs
• View all of the L30 metering values
• View the L30 protection summary
• Generate a service report
GE Multilin
Quick action hot links
Expand the site list by double-clicking
or selecting the +/– box.
Communications status indicators:
Green = OK
Red = No communications
UR icon = report is open
L30 Line Current Differential System
1.3 ENERVISTA UR SETUP SOFTWARE

1.3.5 CONNECTING TO THE L30 RELAY

842743A3.CDR
1
1-15