GE L30 Instruction Manual page 650

G.1 CHANGE NOTES
Table G–3: MAJOR UPDATES FOR L30 MANUAL REVISION Z2 (Sheet 2 of 2)
PAGE PAGE CHANGE
(Z1) (Z2)
--- 11- Add
--- F- Add
Table G–4: MAJOR UPDATES FOR L30 MANUAL REVISION Z1
PAGE PAGE CHANGE
(Y3) (Z1)
--- --- Add
--- --- Add
1-1 1-1 Add
1-5 1-5 Update
2-17 2-17 Update
5-24 5-24 Add
5-84 5-84 Update
5-88 5-88 Update
5-143 5-143 Update
5-228 5-228 Add
Table G–5: MAJOR UPDATES FOR L30 MANUAL REVISION Y3
G
PAGE PAGE CHANGE
(Y2) (Y3)
-- xi Add
Table G–6: MAJOR UPDATES FOR L30 MANUAL REVISION Y2
PAGE PAGE CHANGE
(Y1) (Y2)
All All Update
All All Delete
1-1 1-1 Update
3-8 3-8 Update
Table G–7: MAJOR UPDATES FOR L30 MANUAL REVISION Y1 (Sheet 1 of 3)
PAGE PAGE CHANGE
(X2) (Y1)
All All Delete
Title Title Update
1-1 1-1 Update
2-1 2-1 Update
2-2 2-2 Update
2- 2- Add
2- 2- Delete
G-2
DESCRIPTION
Added Maintenance chapter, moving module replacement content from chapter 3, adding battery
replacement instructions, and moving battery disposal instructions from beginning of manual
Added appendix on RADIUS server configuration
DESCRIPTION
Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal View
figure in chapter 3, and CPU Module Communications Wiring figure in chapter 3
Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
Added General Cautions and Warnings to section 1.1.1
Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
Updated several specifications
Added section 5.2.5e Routing
Updated Figures 5-21 and 5-22 Dual Breaker Control Scheme Logic, sheets 1 and 2
Updated Figure 5-23 Disconnect Switch Scheme Logic
Updated Figure 5-60 Current Differential Scheme Logic
Reinserted section 5.8.5d Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
DESCRIPTION
Added battery disposal information as chapter 0
DESCRIPTION
Minor changes throughout document
Deleted CPU options U and V
Updated Figure 1-1 Rear Nameplate
Updated Figure 3-10 Rear Terminal View
DESCRIPTION
Deleted content pertaining to Ethernet switch
Changed part numbers. Updated address and contact information.
Updated address and contact information
Updated Table 2-1 Device Numbers and Functions
Updated Figure 2-1 Single Line Diagram
Added CPU options T, U, and V to order code table
Removed E, G, H, J, S from CPU options from order code tables
L30 Line Current Differential System
APPENDIX G
GE Multilin