Dräger Babylog 8000 plus Operating Instructions Manual page 91

Transmitting Digital Data
For connecting digital data recording devices
(patient monitor, PC), using the Dräger "BabyLink"
data transmission protocol.
Connect device with interface cable 83 06 488.
Press »Select« button repeatedly, until »BabyLink« is
highlighted.
Press »Start« button. The function of the button
changes to »Stop«.
To abort data transmission:
Press »Stop« button.
Configuring Analog and Digital Interfaces
For configuring the RS232 interface, the analog
outputs, and the marker output.
Press »Cal. Config.« key, then menu keys »Config«
and »Com«.
Display (Example):
Selecting signals and ranges for Analog1 and Analog2
Press »Param« menu key repeatedly, until »Analog1«
is highlighted.
Select desired signal for analog output with menu
keys » « or »
Press menu key »Param« to highlight range selection,
then select parameter range with menu keys
» « or » «.
Proceed in the same way for Analog2.
NOTE: The setting will be retained after the ventilator
is switched off.
«.
Operation
Analog and Digital Interface
91