Extron electronics SSP 7.1 User Manual page 42

Speaker test sequence
To run an automatic test sequence:
1. Select the button. This sends a
Auto
two second test signal to each output
channel in the sequence shown in the
diagram at right. All other speakers
are muted. The test sequence cycles
through each speaker multiple times
until the test signal is switched off.
Click in the
2. Off Select Signal
area to switch off the test signal
Type
and end the test sequence.
To test the speakers manually:
Click to deselect it.
1. Auto
Click the forward ( ) or back (
2. >
buttons to move forward or backward
through the sequence shown in
figure 41.
3. Click Off in the Select Signal
area to switch off the test signal
Type
and end the test sequence.
5.1 Setup
Left Front
channel
2 Sec
Center
channel
2 Sec
Right Front
channel
2 Sec
Right Surround
channel
2 Sec 2 Sec
Left Surround
channel
2 Sec
Subwoofer
Figure 41.
Speaker Test Sequence
)
<
SSP 7.1 • Setup and Control Software
6.1 Setup 7.1 Setup
2 Sec
2 Sec
Right Back
channel
Center Back
2 Sec
channel
Left Back
channel
2 Sec
2 Sec
Figure 42. Manual Test
34