Extron electronics SSP 7.1 User Manual page 37

Speaker Delay Tab
After completing the
Speaker Configuration
Delay tab.
Figure 33.
Speaker Delay Tab
These controls introduce a signal delay for each speaker that has not had its size value set to
. The two main reasons to adjust the signal delay are:
None
To compensate for unequal distances between the speakers and the listener, which causes
•
sound from different speakers to reach the listener at different times.
To compensate for a lack of coordination between the audio and the accompanying video
•
signal.
Speaker distance
When speakers are arranged in a room, there is a
central location or "sweet spot" that offers the best
listening point. However, even in that central location,
the speakers are not necessarily all equidistant from
the listener and the sound from the closest speaker
reaches the listener before the sound from speakers
that are further away.
Speaker distance settings delay the signals going to
each individual speaker (from
the signals from all the speakers are synchronized
and reach the listener simultaneously. The default
setting for each speaker is
0
Speakers that are not available in the current configuration are not displayed. When the back
surround is set to one speaker, the right back speaker is unavailable and the left back speaker is
renamed as the center back.
tab, configure the settings in the
to ms) so that
0 100
Figure 34.
ms.
SSP 7.1 • Setup and Control Software
Speaker
Speaker Distance Settings
29